Our Foam Fusion is the ultimate EPS foam glue! It permeates the foam and bonds around its cells. Other glues containing solvents will dissolve foam over time, but our formula is solvent-free. Our glue is not affected by heat or cold as with glue guns. It works with most rigid foams including Styrofoam, and many soft foams. Foam Fusion bonds foam to almost any porous surface and is easy to apply - simply squeeze or brush on. Plus, Hot Wire Foam Factory tools will cut through this glue.
What customers are saying: "I tried the sample of Foam Fusion, looked at it, and thought I could substitute Elmer’s glue for it. When I did my project, I was very sorry I tried the substitution. Two weeks later, the foam pieces were falling apart with the white glue being totally wet like when I poured it. I had the HWFF people explain that Elmer’s (or plain white glue) is air dry, while Foam Fusion is a chemically drying product. I will never make that mistake again, and I wish I had the two wasted weeks back!" - Michael Kerschner, Amherst, OH WARRANTY: HWFF
Hot Wire Foam Factory warrants this product to be of merchantable quality when used or applied in accordance with the instructions herein. The product is not warranted as suitable for any purpose or use other than the general purpose for which it is intended. Liability under this warranty is limited to the replacement of its product (as purchased) found to be defective, or at the shipping companies’ option, to refund the purchase price. In the event of a claim under this warranty, notice must be given to The Hot Wire Foam Factory in writing. This limited warranty is issued and accepted in lieu of all other express warranties and expressly excludes liability for consequential damages. MSDS